Bearded dragons can survive without food for about 1-2 weeks, but they should not go without water for more than a few days. It is important to ensure they have access to fresh water at all times. If a bearded dragon is not eating or drinking, it is important to seek veterinary advice as soon as possible to address any underlying health issues. **

The hotend is heated down during bed leveling to ensure that the nozzle and the bed are at the correct temperature when the leveling process is carried out. Heating the hotend and the bed helps to account for any thermal expansion or contraction that may occur, ensuring that the nozzle is at the correct height above the bed when the leveling process is performed. This helps to achieve more accurate and consistent bed leveling results, which is crucial for ensuring proper adhesion and layer height during 3D printing. **

If hardly any filament is coming out of the hotend, it could be due to a clog in the nozzle or a problem with the extruder. Check for any obstructions in the nozzle and clean it if necessary. Also, make sure the extruder is properly gripping and feeding the filament into the hotend. Additionally, check the temperature settings to ensure the hotend is reaching the appropriate temperature for the filament being used. If the issue persists, it may be necessary to replace the nozzle or troubleshoot the extruder mechanism. **

No, the dragon tree should not be repotted under running water. Repotting a plant under running water can cause damage to the roots and disrupt the soil structure. It is best to repot the dragon tree in a well-draining soil mix and water it thoroughly after repotting. Additionally, it is important to ensure that the new pot has proper drainage holes to prevent waterlogging. **

The choice between a 12 or 24-volt hotend for 3D printing depends on the specific requirements of the printer and the materials being used. A 24-volt hotend generally provides faster heating and more consistent temperature control, making it suitable for printing with a wider range of materials and achieving higher print quality. However, a 12-volt hotend may be sufficient for basic printing needs and can be more cost-effective. Ultimately, the decision should be based on the specific needs and capabilities of the 3D printer and the materials being used. **

No, bearded dragons do not only eat live food. They are omnivores and can also eat a variety of fruits, vegetables, and insects. It is important to provide a balanced diet for your bearded dragon to ensure they receive all the necessary nutrients. Live food such as crickets and mealworms can be a part of their diet, but should not be the only source of food. **

If the 3D printer hotend is completely clogged with PLA, you can try the following steps to unclog it: 1. Heat the hotend to the maximum temperature recommended for PLA. 2. Use a small drill bit or a thin wire to carefully push through the clog and clear the nozzle. 3. If the clog is stubborn, you can try soaking the hotend in a cleaning solution like acetone or a commercial nozzle cleaning solution. 4. If these methods do not work, you may need to disassemble the hotend and manually clean out the clog. **

To connect the cables to the hotend of the Anycubic Mega S, first, identify the correct cables for the hotend. Typically, there will be a thermistor cable and a heater cartridge cable. The thermistor cable is usually connected to the smaller two-pin connector, while the heater cartridge cable is connected to the larger two-pin connector. Make sure to securely insert the cables into their respective connectors, ensuring a snug fit to prevent any loose connections during printing. Finally, double-check the connections before powering on the printer to avoid any potential issues. **